Have a Question? 502-859-5490
Shopping Cart - 0 item(s) / Total $0 View Cart
Point Sensor Temperature
Point Sensor Temperature

Point Sensor Temperature

Part Number:PS-TEMPERATURE

Availability:

Minimum Order Quantity 50 Pieces, 0

Choose Options

Wireless Frequency
Price:$139.95
  • Minimum Order Quantity (MOQ):50 Pieces
Volume Discount
Quantity
Price
  • 25 - 99
  • $132.95
  • 100+
  • $125.96

DISCONTINUED

Alternative Temperature Sensor with No MOQ
MeshNet Temperature Sensor
Features - All Frequencies
  • Digital temperature measurement 
  • 64-Bit unique ID
  • Battery lasts from 2 to 5 years
  • Complies with part 15 of the FCC rules
  • Water resistant conformal coating on PCB
  • CRC-16 error checked Status, ID and Temperature
  • Low Cost
Features - 418 MHz & 433 MHz
  • Up to 600 foot transmission range
  • Transmission rates from 10 to 17 seconds random
  • Very small ABS Enclosure 1.3” X 2.1” X .6”
  • Internal Loop antenna
Features - 900 MHz
  • Integrated 100mw, 900 MHz SSFH radio for long range performance
  • Range Indoor: Up to 1300 feet
  • Range Outdoor: Up to 1 mile with standard antenna
  • Transmission rate of 5 minutes
  • Small ABS Enclosure 3.25" X 2.5" X 1.125"
  • External 1/4 wave antenna
Part #s

3005-118 - Point Sensor Temperature, 900 MHz (3005-89 replacement)
3006-21 - Point Sensor Temperature, 418 MHz (3005-15 replacement)
5002-09-T - Point Sensor Temperature, 433 MHz

The Point Sensor Temperature sensor is a battery operated digital temperature sensor with a microprocessor controlled 418 MHz, 433MHz, or 900 MHz. FCC certified radio transmitter. The Point Sensor Temperature sensor has an on board time of day clock that allows it to spend most of the time in a low power quiescent state. At predetermined time intervals the clock will wake up the onboard microprocessor. Unique serial number information and digital temperature data are read from a Dallas Semiconductor DS18B20 digital temperature sensor. This information is combined with a CRC-16 error check and transmitted in a very short data packet which results in a very short transmission time. This architecture allows the Point Sensor Temperature sensor to consume very low energy resulting in a battery life of up to 5 years.
The electronics are coated with a conformal material that provides a moisture barrier against condensation; However, submersion in water is not recommended. The service switch is activated by either inserting a special tool through a hole in the top ABS cover (418 MHz & 433 MHz), or a magnet activates an internal read switch (900 MHz). The Sensor is shipped with the transmitter turned off (anytime the Sensor is to be shipped the transmitter should be turned off or must be placed in a shielded container to prevent interference that might cause shipping problems). Start the Sensor by either momentarily pushing the service switch, you will feel the button click (418 MHz & 433 MHz); or by momentarily placing the magnet next to the reed switch as indicated on the product label (900 MHz). When the Sensor starts, a data transmission occurs immediately and a special mark is introduced in the ID field of the transmitted data packet to indicate which sensor is in service or installation. The service switch and reed switch with magnet are also used to put the Sensor in a quiescent mode (no transmissions and very low power consumption). This is the state the Sensor is in when you receive it from the manufacturer. Push and hold the service switch (418 MHz & 433MHz) for 5 seconds or more; or place the magnet near the reed switch (900 MHz) for 5 seconds or more to enter this powered down state.
Information
Browse By Category