Have a Question? 502-859-5490
Shopping Cart - 0 item(s) / Total $0 View Cart
 >  Point Sensor Pulse Counter
Point Sensor Pulse Counter
Point Sensor Pulse Counter

Point Sensor Pulse Counter

 | Questions about this item? Ask here.
(See 1 Questions)
Part Number:PS-PULSECOUNTER

Availability:

Minimum Order Quantity 100 Pieces, 0

Choose Options

Wireless Frequency
Price:$159.95
  • Minimum Order Quantity (MOQ):100 Pieces
Volume Discount
Quantity
Price
  • 25 - 99
  • $151.95
  • 100+
  • $143.96

DISCONTINUED

Alternative Pulse Counter
with No MOQ
MeshNet Sensor with Pulse Counting
  • 30-Bit unique ID with 24-bit Digital Counter and radio transmitter
  • Counts up to 60,000 pulses per minute
  • Switch for installation and service mode indication
  • Broad operating temperature range
  • Up to 600-foot range
  • Transmission rates from 10 to 17 seconds random
  • Up to 100 transmitters can coexist
  • Battery lasts from 6 to 10 years
  • Very small (1.3” X 2.1” X .6”) ABS Enclosure
  • Complies with part 15 of the FCC rules
  • Water resistant coating on PCB
  • CRC-16 checked Status, ID, and counter data
  • Internal Loop antenna
  • Low Cost
Part # 3005-28 - Point Sensor Pulse Counter, 418 MHz
Part # 5002-09-PC - Point Sensor Pulse Counter, 433 MHz
 
The Point Sensor Pulse Counter wireless transmitter is a battery operated digital counter with a microprocessor controlled 418 MHz or 433 MHz. FCC certified radio transmitter. The Point Sensor Pulse Counter has an on board time of day clock that allows it to spend most of the time in a low power quiescent state. At predetermined time intervals the clock will wake up the on board microprocessor. Unique serial number information is read from a Dallas Semiconductor 1-wire digital device and counter data is read from a 24-bit internal counter register. This information is combined with a CRC-16 error check and transmitted in a very short data packet that results in a transmitter on time of only 15 milliseconds. This architecture allows the Point Sensor Pulse Counter to consume very little energy and a battery life of 5 to 10 years results.
 
The Point Sensor Pulse Counter electronics are coated with a conformal material that provides a moisture barrier against condensation. Submersion in water is not recommended. A push button switch in the ABS cover allows the user to activate the service mode. The service switch has three functions: 1)The Point Sensor Pulse Counter is shipped with the transmitter turned off, anytime the Point Sensor Pulse Counter is to be shipped the transmitter should be turned off or placed in a shielded container to prevent interference. Start the Point Sensor Pulse Counter by a momentarily push of the service switch (you will feel the button click) the Point Sensor Pulse Counter is started. 2)The service switch is used as an aid to installation, when the service switch is pushed a data transmission occurs immediately and a special mark is introduced in the ID field of the transmitted data packet to indicate which sensor is in service or installation. 3)The service switch is used to put the Point Sensor Pulse Counter in a quiescent mode (no transmissions and very low power consumption), this is the state the Point Sensor Pulse Counter is in when you receive it from the manufacturer. Push and hold the service switch for 5 seconds or more to enter this powered down state.
Information
Browse By Category